Re: Collector Edition LT4 Build Up |
Subject: Re: Collector Edition LT4 Build Up by PLRX on 2011/1/13 20:29:55 Clean the flywheel's surface with brake cleaner [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov8.jpg[/IMG] Torque flywheel bolts to 74 ft lb [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov81.jpg[/IMG] Torque pressure plate to flywheel to 30 ft lb. Use FSM tighten order. [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov82.jpg[/IMG] Torque the bellhousing to engine block to 37 ft lb [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov83.jpg[/IMG] Tranny do not just "slide in" [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov84.jpg[/IMG] Put tranny on the floor and slide it in sideways and back on the jack. [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov85.jpg[/IMG] SON of A BITCX. This sucker kicked my ***. Torque tranny bolts to 37 ft. lb. Use FSM tighten order. [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov86.jpg[/IMG] ZF Doc Beam Plates [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov87.jpg[/IMG] Discard washers, torque tranny bolts to 37 lb ft [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov88.jpg[/IMG] Discard washers, torque axle bolts to 59 lb ft [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov89.jpg[/IMG] [IMG]http://i275.photobucket.com/albums/jj290/plrx/CE%20LT4/Nov810.jpg[/IMG] The last time I install the ZF it went into the clutch/pressure plate in less than a minute today, this sucker kicked my ass twice. I'm very tired. I need to by a lift :yesnod::yesnod: |