| RE:Headers and Fuel lines |
Subject: RE:Headers and Fuel lines by jsup on 2008/1/27 21:26:15 Salalom4me, thanks. It looks exactly like that diagram you posted. I am taking the lines off up to where the #34 is pointing on the diagram. The fittings were really tight, I had to use a torch to loosen them up (I'm kidding) I thought that without pressure in the system, gas would not pour out. Well, stupid me. I got a face full of gas and had to tighten it while it was running out. Can you, or anyone, tell me if the entire tank will drain if I take these fitting apart? I tightened them back up till I read through the FSM to figure it out. Is this the gas that is in the line? Or the gas that is in the tank? Thanks. |
