Re: 6 Speed manual Trans S-640 Replacing a 4+3 |
Subject: Re: 6 Speed manual Trans S-640 Replacing a 4+3 by FATED on 2008/7/2 18:11:30 I think that somewhere in this string I said that I had to cut the 3/8 master Cyl. shim to fit up the clutch. I didn't have to. Put the rest of the shim back in and the clutch works fine. Drove it this morning and noticed the clutch engaged a little high. Thought about that and put the shim back in. Also the noise is not that bad if you never let it idle in neutral. After all is done I am going to start pulling it all apart for a rear oil seal leak. |