| Re: Make a 350 out of a 400??? |
Subject: Re: Make a 350 out of a 400??? by Durango_Boy on 2009/6/25 18:50:18 Quote: If you didn't purchase the cam already, comp can do the same grind on a smaller base circle for the same cost. I actually already had this cam in a small base circle for strokers. I had to sell it to get the money back for the larger base circle. The reason is because of the V6 lifters I am using for the roller retrofit. The small base circle cam allows the lifters to fall much further into the lifter bore, keep the oil feed hole unsealed and in constant contact with the oil feed. Not only that but when they were down fully they would come completely out of the bottom of the retainer. I figured it was easier to just go back to a larger base circle cam, and deal with grinding the rod bolts. |
