Re: New Roll Bar Pics II |
Subject: Re: New Roll Bar Pics II by rklessdriver on 2009/7/9 2:57:02 Quote:
Thanks I'll have to take a new film of it as it is idled down to 950RPM now but big cams gallop reguardless. The engine is 382 inches and GEN II LT1 based. Stock F Body block w/splayed 4 bolt caps, 11.6SCR, AFR 210 Elims, custom ground Mike Jones hyd roller, T&D shaft mount rockers (1.7/1.7), converted 2925 Super Victor. The bottom end is all ultra light weight stuff Eagle 4340 forged 44lb pendlum under cut crank, Scat Q Lite rods, and Manley Platium Series pistons. It has 36lb FMS injectors, an AS&M mono blade TB and a dyno tune from Ed at The HP Factory. I'm really hoping for 500RWHP but I know considering a small cubic inch 23* motor with a hyd camshaft, I'm doing darn good just to have what I already had. I still have some more stuff comming down the pipe with this car even after it's re tuned. Coilovers and a complete suspension overhaul. Of course I'll have to have that hole the altenator chewed in the hood repaired... It never ends does it? Will |