| Re: Problems getting the new clutch slave installed |
Subject: Re: Problems getting the new clutch slave installed by Jeffvette on 2009/12/28 3:01:56 I will do a manual bleed after installing and tightening down the lines. I put a wrench on the bleeder screw and leave it open (yes some fluid will drain out) but depress it against the oil pan or some other surface, then close the bleeder and then pull the slave off the object I was depressing it against. Then I just pump the hell out of the pedal. Some people get all worked up on this shit. It's not hard. You have dirty nasty fluid in there, undo the bleeder line, let it all run out. You want to get some new fluid in to flush out any impurities, water decomposed rubber, etc. |
