| getting ready for the clutch |
Subject: getting ready for the clutch by Mekanic on 2010/3/10 5:44:01 Well, I finally got a decent job again, been saving my money, and have finally ordered my flywheel (single mass steel Spec with 8k miles on it) Now I just need the rest of the chit, and wanted to find out from my Guru's some opinions on parts. I need a clutch and PP, and I'm leaning tword Carolina Clutch stage 2. The Spec clutches have a high failure rate in the LS world, and the centerforce is too damn expensive, so... thoughts? Also need Hydraulics. There was a guy on the other site who got both master and slave from Advanced, and they were cast! $150 for the pair, may go check mine out. Gonna do the rear main while I'm in there.. stupid not to IMHO. Thinking about a short throw shifter while I have the tranny out. I have a new reverse switch getting installed as well while I'm in there. The only other thing I need is a set of Banski trailing arms, some rear brake pads and a general tune up and she will back at full strength. |
