Re: 1989 L98 Engine rebuild - Part 2: prep and install |
Subject: Re: 1989 L98 Engine rebuild - Part 2: prep and install by Matatk on 2010/6/8 1:26:45 Baby steps..... I received the chip in the mail today from Mick. I had already ordered the Moates adapter. Toys!!! I decided to pull the seat to work under the dash, makes it easier. The ECM is on the passenger side. Pull the lower knee panel and you'll see this: See that white thing on the bottom? That's holding the ECM in with two 10 mm screws...shot from underneath: Hmmm...mine's been replaced before: Pull the dust cover off and remove the stock memcal and adapter, then you can put in the moates adapter and the new chip. The instructions on Moates site are much better than mine, found here: http://support.moates.net/2008/10/31/g1/ That's it for today. Baby steps. Matthew (edited for clarity installing chip) |