Re: Has anyone done a clutch on a ZF6 and why I think Centerforce SUCKS? |
Subject: Re: Has anyone done a clutch on a ZF6 and why I think Centerforce SUCKS? by Josh on 2010/6/30 21:17:13 Look again, the pic above is a push style clutch. Yours is a pull. That is also a valeo pressure plate in your picture. In order to convert to the push style you install a hydraulic TO bearing to actuate the pressure plate and release the clutch. The only change you have to make is to remove the slave cylinder and get a new pressure line made to go between the master cylinder and hydraulic TO bearing. Eventually, the extra pressure will smoke the seal in the stock master. Converting the metal master offered from McLeod will cure this issue. (I don't know if the master is still available, the last time I bought one was a few years ago before B&M bought McLeod) |