| Re: wont stay running |
Subject: Re: wont stay running by bogus on 2011/3/8 0:23:46 hm... 1996 eliminates, to a degree, my #1 concern, the ICM harness. They have a tendency to wear over time on the earlier LT1s. The Opti should throw a code if it is failing, electronically. And if it was the cap, I would suspect that one or 2 cylinders would fail, not the entire motor... odd. I have fallen behind on this thread, so I am not 100% versed in the current suggestions or solutions that haven't worked. My hit list: 1. ICM 2. Coil 3. Coil Wire 4. Coil Wire Harness 5. PCM (potential heat soak problem) 6. Fuel filter/pump 7. God hates you I really don't believe it is the opti. If the electronics fail to send a signal, they fail, and the codes start flying. Mine sure did when the opti died a couple months ago. Have you had to hack/tap into any of the wires on the opti harness? If so, check the solder joints and any heatshrink spots for ground outs. That's all I got for now... |
