Issues after transport! |
Subject: Issues after transport! by Epimax on 2011/2/21 12:35:54 Howdy! I just had the vette (93LT1) transported from MO back to NC a few weeks ago. The car was transported in an enclosed 53ft trailer along with the rest of our household goods. Yesterday, I fire it up and the digital gauge (speedo)starts going crazy. It's blinking on and off, and then starts cycling through all the settings at warp speed. Smack the dash and it stops for a few seconds, then starts again.. I'm thinking the IP may have been knocked loose during transport. If I understand correctly, if there was a problem with the ECM, smacking the dash wouldn't make a difference due to the location, etc, of the ECM itself, correct? One other problem...I replaced the coolant temp sensor for the digital readout due to a H15 code, and the secondary fan turning on at ignition. Didn't work...Still get the code and the fan still comes on. Bad sensor out of the box--maybe wiring harness to sensor? I've taken the dash out before when I replaced the heater core, but I don't think it's that involved to get the IP removed..Do remember dropping the steering wheel, etc... Service Manuals are MIA...Probably in one of the unmarked boxes I've yet to open... Ugh.... I am hoping that removing the IP and checking connections, etc, will resolve issue... Any suggestions/advice/ideas?! Thanks!! |