Become a Fan!
Login
Username:

Password:

Remember Me

Lost Password?

Register now!
Main Menu
Who's Online
235 user(s) are online (199 user(s) are browsing Forums)

more...
Guru Dictionary
Print in friendly format Send this term to a friend  SMC
Sheet Molded Compound.

This is the material that all C4 Corvettes are made of.

It's similar to fiberglass, but much more durable.

The onl...
Supporting Vendors
Platinum
Mid America Motorworks
Mid America Motorworks FREE CATALOG


Gold
FIC 770-888-1662


Registered Vendors
Guru Friends
Supporting Banners

TIRERACK.com - Revolutionizing Tire Buying


Shop for Winter Tires Now!




Support This Site
Report message:*
 

Re: LT4 Hot Cam??

Subject: Re: LT4 Hot Cam??
by BillH on 2011/3/11 13:51:57

Quote:

bam wrote:
I am thinking of upgrading to the LT4 hot cam in my 93 6 spd, 1.6rr's, LT4 springs, EM LT's and have some questions.
1.Anyone tried this (http://www.andersonfordmotorsport.com ... n=com_virtuemart&Itemid=1)would it work on the LT1 engine.
2.I have done quite a bit of research on this especially here; http://www.hashmarks.com/techtips/hot_cam.htm any other info, that others who have done a cam swap that you can give me would be greatly appreciated.
3. I plan to replace the pan gasket, I know some use RTV at some points on the gasket, where and why?
4.Does it take a puller to remove the crank timing gear?
5.What about reinstalling the timing cover and the seals for the w/p drive & opti I know some use a cover to protect the seal when going back on, is this right, where do yo find it?
4.I have new Bosch 3 injectors will they be ok?
5.What about a tune and who do you recommend?
Thanks!


3. The pan gasket: Felpro OS34500R (one piece)
Guys have had good luck both dry and with sealant in the
corners (Felpro says dry). Get rid of the RTV and buy a tube of the Right Stuff, it blows away RTV performance wise and you'll need it for the intake anyway.
Dabs of sealant in the corners help with the irregularities.
Before you install the pan gasket, check for any of the timing cover gasket sticking out where the pan gasket goes, trim with a razor blade if necessary. I use just a little bit of TRS in the corners.

4. Timing cover: FelPro TCS45953 (gasket & seals)
There's a KentMoore tool kit with the gear puller,installer and seal protector, you may be able to find one on ebay.
I haven't tried to change the gears but it may be possible with another puller.
Some guys have made a protector out of a Sharpie pen (this only works half the time,I tried it), the KM protector works perfectly.

Intake gasket: FelPro MS95580

The tune, talk to Mick (Mseven) here.
I have a LT4 HotCam chip that I'd sell cheap. It's out of a 93 TransAm, auto trans and would need to be programed and checked out (I've never run it).
CorvetteForum.guru is independently owned and operated. This site is not associated with or financially supported by General Motors.

Copyright 2008-2015 CorvetteForum.guru

CorvetteForum.guru is a Guru Garage Site (Coming Soon!)

If you have any questions about our site, please contact us at Andy@corvetteforum.guru.

Powered by XOOPS 2.56 Copyright 2001-2014 www.xoops.org

Hosted by GoDaddy.com.