Re: Running Problem |
Subject: Re: Running Problem by mseven on 2011/5/28 11:21:59 voltage drops like I had seen in your first scan can be caused in a few ways. Typically it would be batt. condition or poor alternator charging. Glad you found the source from the batt. ground...I would also check the all and any of the ones from the motor swap. From your first start-up, I mentioned to lower the counts or to turn the min. air screw clockwise as to open the throttle blade. It was reading at least 80 counts, start with 1-1/2 turns and go from there. The target at operating temp will be around 40 counts in p/n. sorry for the late response, I've been working alot lately so I haven't had much time to look on the boards. Mick |