Re: I just bought a KENT MOORE J-35890 ABS test box |
Subject: Re: I just bought a KENT MOORE J-35890 ABS test box by Matatk on 2012/7/10 2:03:25 Quote:
What exactly are you looking for? Please understand that the J-35592 is actually a separate diagnostic testing tool outside of the J-35890. The procedures for using both on the Corvette ABS are outlined in the factory service manual electrical diagnosis section 8A-44-10. The only pinout I can tell you is from the FSM. It is used when testing the wheel sensors for resistance. With the J-35592 connected, the resistance values should read 900-1500 ohms when tested between 4-6 (left front), 11-21 (right front), 9-8 (left rear), 24-26 (right rear). There is a diagram in the FSM that lists each circuit on the controller (with an associated number) for the modulator valve, I'm not sure if each number corresponds with the connector output without physically inspecting the controller. Hope that helps, Matthew |