Subject: Re: head gasket suggestions? by PeteK on 2012/2/8 15:50:29
If it is not an LT1, I normally use the Fel-Pro 7733PT-2 L-98's had a .051 compressed thickness factory gasket, and the Fel-Pro comes in at .039 Inexpensive, and I have never (yet) had a problem with them. If you want thin, Victor makes an .026, but be sure to see how far down the hole your pistons are. If zero deck, you cant use them. ..040 total quench is what I usually target with steel rods. I have run as tight as .034 without issues, but hate to go that tight.
The above assumes you are not boosting, or spraying the balls off it.