| Re: Help LTx 383 build cam issue |
Subject: Re: Help LTx 383 build cam issue by jaa1992 on 2012/5/7 22:28:05 Carp - why isn't this in the books and articles I read a hundred times  Any concerns with balance if I grind the rods for clearance? Crank was balanced to the current rods and pistons. Any concerns with the piston going up and down in the cylinder without rings? Guess its time to pull it all apart again Block is clearanced and the crank weights and rod ends have lots of room. Thanks again to ALL!!!! |
