| Re: Help LTx 383 build cam issue |
Subject: Re: Help LTx 383 build cam issue by jaa1992 on 2012/5/8 1:56:42 ok, pistos/rods are out Timing set is on - I can't beleive I got the marks lined up perfectly the first time! Chain is a little loose, but I can adjust it later with some help. I couldn't get the bolts tight, chain tight at the same time. Tomorrow night I'll do one piston in each hole and rotate a couple times to make sure there is no rod interference. Mark the rod if there is and hit it with the grinder - reminds me I'll pick up an electric grinder tomorrow cause I don't think the dremel will cut it and my compressor won't put out enough air to make the one I have run for more than a couple seconds |
