Troubleshooting...IT'S ALIVE!!!!!!! |
Subject: Troubleshooting...IT'S ALIVE!!!!!!! by bogus on 2013/1/8 7:58:11 Well... kinda... sputters for 2 or three seconds and quits. Back story: read FIRE FIRE FIRE! Short version: Dropping 1996 LT1 in my 1992. keeping engine controller and such 1992. When I go to fire it up, cranks, catches, dies. I am using LTCC - replaced high voltage with 8 LS3 coils. The 96 uses that pin drive to run the opti. My memory tells me that can be installed out of phase, right? Wrong? The early Opti has a spline drive with a gap. I had installed MSD wires, but have since gone back to my Taylors, that I know are good. The ground was suspect, it is now on the front of the ending No codes. I am going to check all the wires near the battery tomoorrow night... maybe a circiut isn't be powered... fuel pressure is 40psi. |