| RE:Where to get heim rod ends? |
Subject: RE:Where to get heim rod ends? by SpectatorRacing on 2008/2/11 21:11:22 The VBP sleeves were flush, so they were clamped along with the bore of the hiem joint. I assume the new ones are the same, they're on the car now so I can't check. From memory they were, or at least very close. CC, if I put a strain guage on the bar, is it possible to measure the actual loads it sees? I already carry a laptop in it for data acq and video. I could run a wire to a guage. What do you think? |
