Re: Bad shudder when backing up |
Subject: Re: Bad shudder when backing up by bogus on 2014/2/4 15:01:26 Yea, Brad, get well soon!!! I hope the flywheel is torqued... I used a torque wrench, in the proper sequence, set at the right ft lb... If this was the flywheel, that means the last two flywheels I installed were lose, or, one came loose, but I use red threadlock on the bolts... Also, the motor mounts are newer. I replaced the original 185k mile units with nice 61k mile units when the engine was swapped. And they were hammered home with an impact gun!! You can email me at andy@corvetteguruforum.com That's the public email for the site, so that's fine!! THANKS!!!! |