Re: Who likes engine porn? |
Subject: Re: Who likes engine porn? by 383tpimachine on 2016/2/21 22:05:51 Well another trip another round of progress. First started by disassembling the rear spindles. Man they were nasty. 100k miles of grime an a blown ujoint caked up. Soaking and pressure blasted. Next they are getting powdercoated like everything else. Have new wheel bearings going in. Next I moved onto making AN fuel lines. This was a MAJOR pain in the ass. Turns out Redhorse fittings that are turns (45*, 90*, 120*) are SLIGHTLY larger than the actual AN size. This means the wrenches will not fit. Had to improvise with a few other wrenches. 10AN feed from tank to pump to split. Split goes from 10AN to dual 6AN. Each rail is fed then looped back to each side of the regulator. Single 6AN return. Wrapped and installed my headers with DEI titanium wrap. Then worked on the Charge pipe. Rough fit Little more trimming or boot and pipe and drilled the holes for the meth injection. It goes off for powdercoating aswell. |