Re: Who likes engine porn? |
Subject: Re: Who likes engine porn? by 383tpimachine on 2016/5/2 5:43:38 Where to start. Happiness and sorrow. Flywheel came in. Fit the crank and floater but not the pressure plate. Sent it back to be inspected by McLeod. Hope to have it back soon. THis held up the trans and driveshaft install. Still no stub axles so no halfshafts which is holding up final measurement for rear top coil mount location. Now onto the good. Dennys Driveshaft and Halfshafts came in. Nitrous ready. Solid 1350 spicer ujoints. Wilwood 6pot front came in. Went from this. to this. After test fit for shims I started the final install. Found out I hated doing safety wire. But got the hang of it at the end. And installed. Also finished installing the passenger side plastics in the wheel well. Meth tank and pump tuck in very nicely behind it all. Center piece took minor trimming to fit over coilover mount. Also got my C beam back from coating. And 4 more boxes. Forgestar F14. 18x10 front deep concave. 18x11 rear super deep concave. Black lugs and valve stem. Testing fitment with charge pipe. Tires are ordered. 285 Hankook fronts and 305 R888 rears. |