Re: 6 Speed manual Trans S-640 Replacing a 4+3 |
Subject: Re: 6 Speed manual Trans S-640 Replacing a 4+3 by FATED on 2008/5/27 12:57:39 Any dimensions I will probably take myself when the time comes. I got the transmission, clutch Assy. and bell housing for $1250 so if all the parts are as good as they look, it should be a low cost swap. I will also be changing out the engine at the same time. I got a 2 piece seal crank so I could re use my 85 4+3 flywheel. So much for planning ahead. Looks like a 1 piece seal would have given me a few more options. It seems that I have about all the parts to do this either way. Right now I think I will go the Central Coaster way and use the surfaced flywheel and all of the ZF stuff. Coud change my mind later. The only real issue I can see with that is the TOB. I was curious as to why a smaller master Cyl. coldn't be used to cure the issue of the TOB blow out on the push install? I really apreciate all of the info I have got from you folks. Regards, |