Re: Pumpkin swap/u-joints/wheel bearings/suspension junk (PICS!) |
Subject: Re: Pumpkin swap/u-joints/wheel bearings/suspension junk (PICS!) by PeteK on 2009/4/19 16:42:26 Sadly, I do know the torque specs. 24 ft lbs are the requirements for the tail housing bolts. One last tip: When you change the drive gear on the output shaft, the clip will likely fall. Be careful when putting it back. It has a locating tit that fits in a small hole in the output shaft. However, there are 2 holes close together. You want to stick the tit in the rearmost hole. c4 vette's use this hole, all other cars use the front hole. |