Re: Pumpkin swap/u-joints/wheel bearings/suspension junk (PICS!) |
Subject: Re: Pumpkin swap/u-joints/wheel bearings/suspension junk (PICS!) by Matatk on 2009/6/8 11:55:23 Quote:
I would remove the torsion bar completely, it's only 2 nuts and keeps the thing out of the way. Are you changing the u-joints? Straps should have already been taken off by this point. If so, once the torsion bar is off you can loosen the bolts connecting the c-beam to the pumpkin now. Make sure you support the trans and c-beam (I left mine hanging on the brake cable temporarily, not recommended. Your choice if you want to take the driveshaft out now or after you drop the pumpkin. (I did mine after) You can then support the pumpkin on a jack and remove the two bolts holding that in and lower it down. Matthew |