| Re: 86 vette switching an auto trans to a manual transmission |
Subject: Re: 86 vette switching an auto trans to a manual transmission by Flashman on 2009/8/2 3:51:09 Yeah well tomorrow is the day to get this job done. Its not fun anymore. More like a full time job. What a bitch it was getting that C beam in after the trans was in. Heres the list that needs to get completed tomorrow: 1. Install/adjust shifter & rods and seal hole in tunnel 2. Bolt in C-beam and driveshaft 3. Modify/connect trans cooler lines 4. Fill overdrive with trans fluid 5. Connect relay and wires for overdrive switch, clutch etc. 6. Install exhaust 7. Install seats, console, interior etc. 8. Install TV cable 9. Install battery and side panel 10. Install new leather shift boot 11. Bleed clutch and slave cylinder Anybody have any tips on bleeding the clutch/slave cylinder? Joe Flash |
