| Re: Dana 36 Pinion Seal |
Subject: Re: Dana 36 Pinion Seal by CFI-EFI on 2009/6/29 14:35:37 The seal seals against the drive line yoke installed on the pinion, not the pinion (shaft?). The seal surface on the yoke could be worn or grooved as suggested or possibly the pinion nut wasn't properly tightened and the pinion is moving. Of course that would likely ruin the pinion bearings. There is a baffle or slinger on the pinion between the bearings and the yoke. If left out it would tend to over load the seal with grease to try to control. RACE ON!!! |
