Re: DRM Trailing arm bracket install Banski Trailing arm install |
Subject: Re: DRM Trailing arm bracket install Banski Trailing arm install by Aboatguy on 2009/8/29 21:30:19 Assemble DRM bracket and Banski arms on deck torque to 70 ft lbs [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess.jpg[/IMG] Get ready for quick reassembly [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess1.jpg[/IMG] Plan your route [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess2.jpg[/IMG] [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess3.jpg[/IMG] [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess4.jpg[/IMG] Install rear bolts and hardware leave every thing LOOSE [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess5.jpg[/IMG] Align front bracket [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess6.jpg[/IMG] Install bolts a turn or two (hand only [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess7.jpg[/IMG] Torque bolts 70 at the front 90 at the rear. [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess8.jpg[/IMG] [IMG]http://i14.photobucket.com/albums/a342/aboatguy/Newprocess9.jpg[/IMG] Check everything again. DONE!!!!!!!! I used red loctite on all of the bolts. Now I have to figure out if I can do the camber brackets with out dropping the exhaust... Catch you later. Mike |