Re: DRM Trailing arm bracket install Banski Trailing arm install
Subject: Re: DRM Trailing arm bracket install Banski Trailing arm install by CentralCoaster on 2009/9/22 5:17:46
Quote:
BrianCunningham wrote: I went over the kit again with the new spacers.
They're going to work out, all I needed was some thick washers no machining. The SAE 5/8ths fastners in METRIC holes is just too sloppy for me.
5/8" = 15.875mm
If they're tight it won't make a difference. As long as the slop in the hole is still under the bolt head, it'll be fine in the case it does come loose.
FWIW, I had my inner camber rods come loose, so I put locktite on them. Made for a helluva lot of camber in the meantime! I think the stock nuts are those oval type locking nuts.
