Forums - CorvetteForum.guru

Re: Shotshell reloading

Subject: Re: Shotshell reloading
by tjpreul on 2012/3/3 13:34:57

Quote:

istter1 wrote:
I can't tell if there is a station to seat a new primer but that was a good loader. You push the silver bar from one station for power and the next to the other for shot. You would need a scale to see the amount of shot and powder each side loads/ unless it is marked on the bar. There won't be a pretty roll on the close of the case but if you aren't using an auto or a pump works great.

Its hard to see in the bottom picture, but they both have five stations. There is one on the back left to push out the primer. Then the front left installs the new one. In the slide bar there are powder and shot bushings that you change for load size. I only have pumps. I remember helping my uncle reload with these reloaders when I was young, and that the crimp would have to be fixed once in a while.

1984 Engine