|
Register To Post |
freakd | so 10 years ago | ||
Master Guru
|
the top of the engine was rebuilt, i'm starting to think that the top part is now leaking, not a good thing. i know the plenum and intake were off the vehicle. is it possible that it could be leaking, and what are the consequences. i'm going to my mechanic tomorrow to verify this, and my fan motor., if it is bad, then the car goes up, until i can afford to rebuild the engine. if this happens, i want to rebuild it so i can run a superram
|
||
Posted on: 2006/7/30 19:12
|
|||
Transfer |
brut | RE:so 10 years ago | ||
Guru Emeritus
|
When you say "top" do you mean heads, cam, and so forth?
|
||
Posted on: 2006/7/30 19:24
|
|||
Transfer |
freakd | RE:so 10 years ago | ||
Master Guru
|
where the intake is :thumbright:
|
||
Posted on: 2006/7/30 19:31
|
|||
Transfer |
brut | RE:so 10 years ago | ||
Guru Emeritus
|
So just the plenum, fuel rails, injectors, manifold and runners were removed?
If it was ten years ago, depending on what they used for gaskets, they could verty well be shot especially if everything wasn't tourqed down to specs. If you are debating doing the Superram swap, its getting close to being a good time to do it, during the winter(if you have a heated garage). Plus, if you are not wanting to buy new, I am sure they will be coming available soon on CF due t o people's winter projects. |
||
Posted on: 2006/7/30 20:55
|
|||
Transfer |
freakd | RE:so 10 years ago | ||
Master Guru
|
ok,i took a light and stated digging, doesn't look bad, there appears to be no water in my oil and no oil in the anti froze, whew, which is a relief. the original leak appears to have stopped, after i filled up the surge tank to where it needed to be, but i am still taking it to my mechanic tomorrow
|
||
Posted on: 2006/7/30 21:24
|
|||
Transfer |
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
|