| Dana 36 Guru's step inside |
Subject: Dana 36 Guru's step inside by jhammons01 on 2009/3/1 17:59:39 I have an issue with a bad vibration coming from the rear end. I've replaced Wheel Bearings and U-joints on the half shafts..... while doing the Wheel bearing CentralCoaster and I noticed that there was a lot of slop in that small shaft that comes out of the Dana 36. So, the usual response is get another pumpkin and swap it out. OK that makes sense....but me being me.....why can't that single bearing for that small yoke be replaced? If the rebuild kit is ~$95 with new bearings......wouldn't this be the way to go after this issue? I know there is something about aligning the Gears that I'm not privy to......but isn't this just one more Tech issue that we need to discuss openly? There just isn't much when you search out the "rebuild Dana 36" topic. ANY AND ALL opinions are appreciated.......Let's work this problem. |
