All Posts (gwnewlon)
Re: I just bought a KENT MOORE J-35890 ABS test box |
||
---|---|---|
Guru Newb
Joined:
2012/7/9 3:54 From Moreno Valley CA
Posts:
4
|
Thank you, I think I'll give it a try.
Gary Newlon
Posted on: 2012/7/14 4:01
|
|
Transfer |
Re: I just bought a KENT MOORE J-35890 ABS test box |
||
---|---|---|
Guru Newb
Joined:
2012/7/9 3:54 From Moreno Valley CA
Posts:
4
|
Matthew,
Thank you so much for taking the time to get this information back to me. I can probably get my hands on the parts to fabricate the cable. Which wire goes where is the problem. You're probably correct with the being had part. My 87 Corvette's ABS system functions properly. I just would like to have one to test the system with. Respectfully, Gary Newlon
Posted on: 2012/7/12 5:23
|
|
Transfer |
Re: I just bought a KENT MOORE J-35890 ABS test box |
||
---|---|---|
Guru Newb
Joined:
2012/7/9 3:54 From Moreno Valley CA
Posts:
4
|
Matthew, Thank you for your information. I have the ABS tester with it's Manual. The manual has picture of the J35892 connector harness. The tester arrived without the connector harness. So, I need a way to get the tester to talk to the modulator. According to the manual the tester cycles the modulator pump motor and will use the modulator to cycle each wheel solenoid to stop the rotating wheel. Should there be a J35892 cable housing available I would like to purchase it. If there is a drawing showing the wire routing or pin out I would like to purchase it.
Any help would be appreciated. Best Regards, Gary Newlon
Posted on: 2012/7/11 17:08
|
|
Transfer |
Re: I just bought a KENT MOORE J-35890 ABS test box |
||
---|---|---|
Guru Newb
Joined:
2012/7/9 3:54 From Moreno Valley CA
Posts:
4
|
I also have purchased a Kent Moore J35890 which came without the J-35892 cabling. If the offer of providing a drawing or sketch showing the pinout, I would be very greatful.
Gary Newlon
Posted on: 2012/7/9 4:38
|
|
Transfer |