I'm make 422 at the rear using 255 lp pump with 32 lb injectors @ 43.5 and running at 80% duty cycle.

Quote:

Yes it does increase with the RPMs. I went over the motor with a stethoscope and it sounds loudest around the center bolts on the drivers side intake and valve cover.

That started the ticking.

No codes and it is running fine just the tick. I did get some LS7 lifters to replace the old stock ones. So I'll have to look around after I get the intake off.

Very nice

Some nice look'n engines.

I've got a sound coming for my '95 LT1 with 103k. The trans and clutch do not change the noise and none of the rockers are loose. It sounds like it coming from inside the motor with the valve covers off. You can hear in the vid that it ticks once every two seconds. So do you think could be rotating that slow or could a bad lifter be the cause?

tick sound

Good place to look is eBay. I got my last week for $10.

Opening day is going to be rescheduled.

NCperformance

The "what do you mean?" part kind of threw me. Will good luck with your search.

eBay ZF6
The black tag the stronger early model and blue tag was the later model.

This tracks got nothing but corn around it.

A new ZF6 will sell for $1500 on eBay. The same person has been selling both black and blue W/O the bell housing.

Quote:


Love the SS hood.

[IMG]http://i98.photobucket.com/albums/l278/ijonnymac/65218-R1-14-11_015.jpg[/IMG]

Central Illinois on highway 51 south of Decatur north of Pana.

Nothing like a job done right. I've got my winter mods done and moving on to my spring mods.

I found a new one on eBay looks like I got a good deal.
SPX-KENT-MOORE-J39046

Just got a Kent-Moore J-39046 off eBay for $10. I would like to know if all the parts came with it. I've got J-39046 1-4 plus the thrust bearing, flat washer and some bolts.

[img width=300][/img]

Just coming over from the CF. The Vettes up on jack stands getting a set of EM headers installed and I need a new place to hang out. I really am tired of looking at snow.

NC performance INC.
This series of events will be run on the grounds of historic Motion Raceway in Assumption Illinois. Once considered one of the finest drag strips in the state, it’s a 1/4 mile track that was host to many legends of the sport over the years. John Jones has been gracious enough to let us use this property for a trial season of roughly 5 events in 2008. This is only on a trial basis and our success and ability to make something regular out of this depends on YOU! Please follow the rules and help us bring a truly unique event to central Illinois.

The Format

We’re capturing all the excitement of street racing in a safe, controlled, family friendly atmosphere. Most importantly, we want to get kids off the street and the racing where it belongs. The races will be 1/8 mile, flag started with no timing equipment. Go heads up or negotiate lengths. Run what ya brung, open to all cars trucks and bikes. Our only stipulation is that they must have mufflers. Slicks or street tires are acceptable. The grounds are sparse with no electricity or grandstands so bring your lawn chairs. We will have food vendors and porta-potties available, as well as EMTs and a full security staff.

Fees and Schedule

Racers at the gate $20. Racers pre registered $15.

Racers with a high school ID $10.

Clubs or groups of five or more pre registered $12. Spectators $6. Kids 12 and under free.

First event is scheduled for May 3, 2008. Gates will open at 7 AM. Racing will start around 10AM and last until dusk. Hope to see you there!

I needed to drive down to the track just to see whats there. They are cleaning the place up but it may not be much more then a over grown field.

Thanks for the link

Great color

Nice Vette

Little Chicago