|
Register To Post |
RIISITAS | Kent Moore 39046 Tool | ||
Guru Newb
|
Where's the best place to buy one of these tools?
|
||
Posted on: 2008/8/24 0:12
|
|||
Transfer |
biggrizzly | Re: Kent Moore 39046 Tool | ||
2011 Memorial Day Car Show Winner!
|
Well, I have dealt directly with the people at Kent-Moore tools and they are highly efficient and good people to deal with. I think I'd give them a call and see what they can do for you. Also, you might put up a wanted ad over at CF to see if anyone wants to sell one to you.
The puller installer set is a Godsend when pulling that hub. No better way to do it. I was lucky enough to borrow one. Keep searching, someone will have one for sale or even eBay often has them listed too. |
||
Posted on: 2008/8/24 1:14
|
|||
_________________
Don Haller Corvette Club of America 94Coupe, 383Stroka, PeteK Trans, 3000stall, 3.54rear, Konis and bigger sways. |
|||
Transfer |
RIISITAS | Re: Kent Moore 39046 Tool | ||
Guru Newb
|
Will do. I figured if I'm going to keep the Vette I might as well have the tool.
|
||
Posted on: 2008/8/24 19:35
|
|||
Transfer |
CentralCoaster | Re: Kent Moore 39046 Tool | ||
Senior Guru
|
What are you removing?
There's plenty of free rental tools that may do the trick. |
||
Posted on: 2008/8/25 2:33
|
|||
_________________
1985 Z51, ZF6 |
|||
Transfer |
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
|