|
Register To Post |
Jonnymac | Tick sound with VID | ||
Guru Newb
|
I've got a sound coming for my '95 LT1 with 103k. The trans and clutch do not change the noise and none of the rockers are loose. It sounds like it coming from inside the motor with the valve covers off. You can hear in the vid that it ticks once every two seconds. So do you think could be rotating that slow or could a bad lifter be the cause?
tick sound |
||
Posted on: 2008/4/10 3:49
Edited by Jonnymac on 2008/4/10 20:58:17 |
|||
Transfer |
Calm | Re: Tick sound with VID | ||
Senior Guru
|
Sorry, but I can't think of ANYTHING in your lt1 that rotates every 2 or 3 seconds at 750 (+/-) rpm.
I listened quite a few times....it puzzles me. The only possible conclusion I came to was either a possible Knock issue OR a Vacuum 'build up' issue, causing something or other mechanical to 'trip'? Sorry I can't think of anything else right now. How's it running? And are you throwing any codes? |
||
Posted on: 2008/4/10 5:21
|
|||
_________________
1995 Forged 385 ZF6 227/234 1.6 FIC30# MSD BBK SS SLP Bullets X-Pipe DynoMax |
|||
Transfer |
Jonnymac | Re: Tick sound with VID | ||
Guru Newb
|
No codes and it is running fine just the tick. I did get some LS7 lifters to replace the old stock ones. So I'll have to look around after I get the intake off.
|
||
Posted on: 2008/4/10 20:57
|
|||
Transfer |
TommyT-Bone | Re: Tick sound with VID | ||
Chair-man of the bored
|
Usually I'll take it out to some back country open roads and give it something to tick about.
|
||
Posted on: 2008/4/10 23:14
|
|||
Transfer |
Jonnymac | Re: Tick sound with VID | ||
Guru Newb
|
That started the ticking.
|
||
Posted on: 2008/4/11 0:06
|
|||
Transfer |
CentralCoaster | Re: Tick sound with VID | ||
Senior Guru
|
I was going to suggest maybe a relay or solenoid going haywire, but it sounds like a pretty heavy tick, almost metallic.
Does it speed up at all when you rev the motor? If not, you can be assured it's not a rotating part. |
||
Posted on: 2008/4/11 16:35
|
|||
_________________
1985 Z51, ZF6 |
|||
Transfer |
Jonnymac | Re: Tick sound with VID | ||
Guru Newb
|
Yes it does increase with the RPMs. I went over the motor with a stethoscope and it sounds loudest around the center bolts on the drivers side intake and valve cover.
|
||
Posted on: 2008/4/12 22:13
|
|||
Transfer |
You can view topic.
You cannot start a new topic.
You cannot reply to posts.
You cannot edit your posts.
You cannot delete your posts.
You cannot add new polls.
You cannot vote in polls.
You cannot attach files to posts.
You cannot post without approval.
|